recordinghacks

Royer Labs R-122 Mk II

Bidirectional Active Ribbon Microphone

The R-122 Mk. II is a second-generation design of the venerable R-122 active ribbon mic. It shares the original mic’s ribbon geometry, transformer, and circuitry, but adds two switchable features: a high-pass filter, and a pad.

The Mk II will replace the R-122 in Royer’s product line; it is expected to begin shipping in Q2-2015, at an MSRP of $1995 (which is $100 more than the R-122).

According to Royer Labs, the original R-122 design can, in cases where the phantom power supply is compromised, or the preamp’s input impedance is very high, run out of headroom. The distortion happens within the active circuitry.

The pad on the Mk II will offer at least 10dB attenuation; the actual value has not yet been determined. The high-pass filter will roll off frequencies below 80Hz. These features will make the microphone much more usable for high-SPL sources, and for close-miked instruments: because ribbon microphones are very sensitive to proximity effect, the switchable filter allows the boosted bass frequencies to be filtered out right at the microphone, while the pad increases headroom available to loud sources.

Note: the photo above is of the standard R-122; the front of the Mk II body differs from the pictured original in only one respect: the new version says “Mk II” under the “R-122” legend.

The two new switches are mounted directly to the microphone’s circuit board, and are accessed through two small slots cut into the rear face of the microphone body.

When the pad and filter are disabled, the R-122 Mk II sounds exactly like the original R-122; the signal path, with switched features disabled, is identical to the original mic’s signal path.

For more information on the R-122’s offset ribbon transducer and active gain circuitry, see the profile of the R-122, linked from the sidebar.

The R-122 Mk II will be officially announced at the NAMM show in Anaheim, CA, in January 2015.

Permalink: Royer Labs R-122-Mk-II

The mic was released in 2015.

Specifications

Pickup Patterns	Pads & Filters
Bidirectional (14.1 mV/Pa; 30 - 15,000 Hz)

Ribbon Construction	Impedance	SPL/Noise
Gauge: 2.5 microns	n/a	Max SPL: 135 dB Self-noise: 20.0 dB(A)

Weight	Length	Max Diameter	Interface(s)
n/a	206mm (8.11'')	26mm (1.02'')	3-pin XLR male (1)

Power Specifications
Requires phantom power

Did we get anything wrong on this page? Please let us know!